For 2.5" Hard Disks: Place the hard disk in the hard drive tray. Turn the tray upside down and tighten
screws into the four spots indicated below to secure the hard disk.
3 After securing the hard disk and tray, insert the loaded hard drive tray into the empty hard drive bay.
Important:
Make sure the hard drive tray is completely inserted. Otherwise, the hard disk might not function
properly.
4 Push the handle to secure the hard drive tray.
5 Repeat the steps above to install all prepared hard disks.
6 Hard disk positions are numbered as shown below.
Note:
If you want to set up a RAID configuration, we recommended all installed hard disks be the same size in
order to optimize hard disk capacity usage.
8 Chapter 2: Hardware Setup