Aaronia NF-5030S Manual page 47

Table of Contents

13.0 Tips and Tricks

Exposure limit calculations and display with "weak" signals

In such a situation, simply set the marker level Marker to a higher sensitivity. The

"20%" setting corresponds to the highest sensitivity.

"Conversion" of measurement results into other physical units

As you already know, using the HOLD feature, you can "freeze" a measurement

result. After doing this, you can simply change to a different unit [T, G, A/m, dBm,

dBµV] or [V/m, dBm, dBµV] and the old value will instantly be converted to the

newly selected unit after you leave the menu. You can repeat this procedure as

often as you wish. Very practical for a quick conversion from e. g. Tesla [T] to

Gauss [G].

Correct settings for manual input/measurements

We recommend our PC analysis software "LCS" or „MCS" for such tasks. Here,

you can find many optimized "profiles" from mains power to TCO99 or energy-

saving lamps. In addition, information such as channel numbers etc. are also

displayed. These parameters can then simply be "copied" and transferred to

SPECTRAN.

However, we also have a special setting just for 50Hz/60Hz mains power:

Simply use quick measurement via key 2. In this mode, 50Hz resp. 60Hz sig-

nals from power lines, electrical appliances or high-voltage lines can be measu-

red and displayed quickly and easily.

PC analysis

We offer you our FREE PC analysis software "LCS" and „MCS" for SPECTRAN

at our homepage. Only this PRO application shows the full power which is insi-

de SPECTRAN. You should use this software whenever possible to be able to

fully and optimally use the power of your instrument.

Table of Contents

Spectran nf