Exposure Limits Mode - Aaronia NF-5030S Manual

Table of Contents

5.6 Exposure limits mode

(The DISPLAY MODE status field displays "EXPOS.-LIMITS")

entire range of different exposure limits. You can select the desired

exposure limit by using the right/left cursor keys.

led introduction to these exposure limits on pages 47 and following in this

manual.

Please try it yourself: Select all the different exposure limits and compare the

results. The available exposure limits are:

xTESLA = Shows the readout in Tesla

ICNIRP = ICNIRP recommendation also German limit (General population)

BGRB11 = BGFE limit for workplace exposition (exposition class 2)

BImSch = 26. BimSchV (Indutrial German limit) (only 16,66Hz, 50Hz, >10MHz)

TCO99 = International limit for computer screens (only from 5Hz-400kHz)

In our fictional example, the exposure limit bargraph shows an approximation to

the German ICNIRP limit of 69%. When EXCEEDING the exposure limit, the dis-

play will show percentages above 100% (for example, 128,00 = limit exceeded

by 28%). When exceeding the exposure limit by more than 999.99%, the display

will show "***.**", indicating overflow.

5.0 Your first measurement / Modes

Press the Enter key until the

field

shows "EXPOS.-LIMITS".

As usual, the strongest signals will be shown along with

their frequencies and levels as markers, as in the spec-

trum analysis mode. The large main display will again

show the level of the strongest signal found.

However, in the graphics display below, the strongest sig-

nal will be shown now as a percentage in relation to an

exposure limit: As various very different exposure limits

and recommendations are existing for the various fields

of interest and professional groups, SPECTRAN offers an

display mode status

Find a more detai-

Table of Contents

Spectran nf