Table of Contents
Advertisement
5.0 Your first measurement / Modes
Using our Option 006, which can be retrofitted as an upgrade at any time,
you can also measure STATIC magnetic fields, like the geomagnetic field (geo-
logical dislocation) or the strength of magnets (for example in loudspeakers). To
do this, just press key 6 and select the MSta sensor (possible choices are X-
MSta, Y-MSta and Z-MSta).
If you have an NF-3020 or better, you can also select the external input (SMA
socket), which allows you to connect arbitrary external sensors like large, high-
ly sensitive coils, testing probes, or other special antennas. You could also sim-
ply measure a voltage. This input provides you with a whole range of new pos-
sible applications and converts SPECTRAN into a versatile all-rounder. For
using the external input, press the key 6 and choose Analog.
5.2 Choosing the mode of operation [Enter key]:
All SPECTRAN models offer
- SPECTRUM analysis (graphical display of signal levels and frequencies)
- EXPOSURE LIMIT display (percentage of a particular exposure limit)
- AUDIO output (makes modulated signals audible)
You can switch between the different modes of operation at any time by
using the Enter key.
5.3 Mode Spectrum analysis:
(The DISPLAY MODE status field displays "SPECTRUM")
even notice.
The
main display
Firmware V 1.0 / © 2005-2013 by Aaronia AG, D-54597 Euscheid, www.aaronia.com
3 different MODES OF OPERATION:
Press the Enter key until the
reads "SPECTRUM". SPECTRAN will now provide a rea-
dout similar to the one shown in the picture on the left.
Should the large
signal is found. In this case, you probably have to mea-
sure closer to the signal source. During every measure-
ment, a small dot will constantly move from the left to the
right edge of the upper part of the
Only when this point reaches the right edge, the mea-
surement is completed and all readout values are
updated, very often it will be so fast that you won't
shows the current field strength, in our example it is 45,15µT.
display mode status field
main display
show "0000", then no
graphics
display.
11
Advertisement
Table of Contents
