Advertisement
OPERATIONAL MODES
HIGH mode: Press the Power/Mode Switch once. From any mode, press
twice (once for OFF and once for ON) to get back to HIGH mode.
LOW mode: From HIGH mode, press and hold the Power/Mode Switch
for 2.5 sec.
FLASHING mode: From LOW mode, press and hold the Power/Mode
Switch for 2.5 sec. To get back to LOW mode, press and hold the Power/
Mode Switch for an additional 2.5 sec.
OFF or to EXIT a mode: Press the Power/Mode Switch once.
NOTE: The light does not retain the mode in memory . Once you turn the light
ON, you will have to reselect the mode you desire.
ASSEMBLING THE WEDGE
The BT2+ comes with one (1) Wedge and it is an optional accessory for the
BTS. The purpose of the Wedge is to keep doors open. It can be placed under
a door or at the door hinge opening.
Place the narrow end of the Wedge on the bottom notch (located above the
Battery Door). Maneuver the wide end of the Wedge to the top notch (located
below the Charge Indicator).
6
Advertisement
