Page 1
OPERATOR'S MANUAL Cat. No. No de cat. 0730-20 28 VOLT CIRCULAR SAW TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.
GENERAL POWER TOOL SAFETY WARNINGS WARNING READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS . Failure to Save all warnings and instructions for future reference The term “power tool” in the warn- ings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. attached to a rotating part of the power tool may WORK AREA SAFETY result in personal injury.
Further safety instructions for all saws coins, keys, nails, screws, or other small metal – Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an un- terminal to another. Shorting the battery terminals controlled saw to lift up and out of the workpiece toward the operator;...
Be aware of the time it takes for the blade to stop after switch is released. These carry important information. If unreadable or missing, contact a MILWAUKEE service facility for a free replacement. Some dust created by power sanding, sawing, grinding, drilling, and other construction 1.
Page 5
Then, check the operation again by starting with step 1. back into place, contact a MILWAUKEE service facility for repairs. 4. Lift the depth adjusting lever up towards the...
4. Tighten the bevel adjusting knob securely. 1. Remove battery pack. 2. To adjust the angle of the cut, hold the saw by The shoe has been adjusted at the factory to a 90 the handle and loosen the bevel adjusting knob. degree setting.
Page 7
MILWAUKEE service facility. The brake is not a substitute for the guard, and you must always wait Pocket Cutting...
Fig. 8 on the battery pack. If the tool still does not work properly, return the tool, charger and battery pack, to a MILWAUKEE service facility for repairs. WARNING To reduce the risk of per- tool, battery pack or charger in liquid or allow...