Inverter Details - Assa Abloy Norton LEO 5700 Series Installation And Instruction Manual

Power operator

Hide thumbs Also See for Norton LEO 5700 Series:

Installation and instruction manual (12 pages)

Instructions (4 pages)

Table of Contents

E. Adjust Closing Position Magnet (See Fig. 3) - With

door in the closed position, use finger to slide Closed

Position Magnet so it aligns directly with the Reed

Switch.

Open Position

Magnet

Position Ring

F. Adjust Open Position Magnet - Use fingers to slide

115Y

115/230VAC IN

230Y

MOTOR OUT

(Adjustments made in the shaded

area should be performed by

Authorized Factory Personnel.)

WARNING

Electric

Shock Risk

Norton® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company.

Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.

4. Final Electrical and Mechanical Setup Continued

Reed Switch

Closed Position

Magnet

Figure 3

TB501

STATUS LEDS

JMP503

H/O TM

H/O TQ

M/DLY

120 HIGH VOLT POTENTIAL PRESENT. MAKE

SURE POWER IS TURNED OFF DURING

INSTALLATION PROCEDURE.

F cont. Open Position Magnet 180° from Open Position

Magnet.

G. Flip Breaker Switch to "RESET" to turn power on.

Jump terminals 1 and 2 (as shown in Fig. 2) to

activate door. Note open position of the door. Allow

door to close.

H. Use finger to readjust the Open Position Magnet to

desired door open position.

I. Repeat Step G to verify door open position.

J. Make all connections necessary for any accessories to

the 4-position Accessory Terminal (see Pages 10-11).

K. Make necessary adjustments to inverter (see Page 9).

Replace cover and cover screws.