Samsung NX58 560 Series User Manual page 56

Maintaining your appliance
56 English
NX58N5605SS_AP_DG68-00526B-01_EN+MES.indb 56
2. Lift off and remove the burner grates
from the cooktop. Make note of the
burner sizes and locations of all the
surface burners.
3. Lift off burner caps from top of the
burner heads.
4. Lift the burner heads off the valve
manifolds and starter electrodes.
5. Clean all removable burner parts in
warm, soapy water. Do not use steel-
wool pads or abrasive cleaners on any
burner part.
6. Rinse thoroughly and completely dry all
parts before they are reassembled.
NOTE
Starter electrodes are not removable and
should only be wiped clean when the
controls are in the OFF position.
7. Set all burner heads on top of the
manifold valves in the same location
you removed them from. The hole on
the side of the burner heads goes over
the electrodes. The burner heads are
correctly installed when they are flat on
the top of the manifold valves.
8. Set all burner caps on top of the burner
heads.
These also need to be flat on top of the
burner heads to ensure proper and safe
operation.
Precise Simmer Burner (RR)
NOTE
The caps on Precise simmer burner (RR)
and inside Double-ring Burner (RF) can be
interchangeably used.
Flat surface Concave line
2020-06-22 오후 4:37:47