Samsung NX58 560 Series User Manual page 53

Stainless steel surfaces
WARNING
Do not use a steel-wool pad or abrasive cleaners on stainless steel surfaces.
Abrasive pads and cleaners will scratch the surface and damage the surface finish.
NOTE
To prevent any discolorations and/or grease stains, we recommend cleaning and
removing any spills, spots, and grease from the range after each use.
Stainless steel
surfaces
NX58N5605SS_AP_DG68-00526B-01_EN+MES.indb 53
1. Wipe off any spills with a damp, soft
2. Apply an approved stainless steel
3. Dry and buff with a clean, dry, soft
4. Repeat steps 2 and 3 as necessary.
WARNING
Do not spray any type of cleaner into the manifold panel holes. Within these
holes are ignition switches which carry the current that lights the surface burners.
Spraying into them could damage the range.
Oven racks
• If the racks are left in the oven during a self-cleaning cycle, their color will
turn slightly blue and the finish will be dull. After the self-cleaning cycle is
complete and the oven has cooled, rub the sides of the racks with wax paper
or a cloth containing a small amount of oil. This will help the racks glide more
easily into their tracks.
• Gliding racks may be cleaned by hand with an abrasive cleaner or steel wool.
During cleaning, be careful not to allow water or cleaner to enter the slides on
the sides of rack.
NOTE
• Do not clean in a dishwasher.
• If the rack becomes hard to remove or replace, lightly wipe the oven rack
guides with cooking oil. Do not wipe cooking oil on the slides.
• If the rack becomes difficult to slide, the rack may need to be lubricated using
Graphite Lubrication.
cloth.
cleaner to a damp, clean cloth or paper
towel. Clean a small area carefully
following the instructions on the
cleaner. Stainless steel should always be
cleaned with the grain in the stainless
steel, if applicable.
cloth.
English 53
2020-06-22 오후 4:37:46