Troubleshooting - Scheppach HM254 Translation Of Original Instruction Manual

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Uni-
on, different regulations may apply to the disposal of
waste electrical and electronic equipment.

14. Troubleshooting

Fault Possible cause
Motor, cable or plug defective,
Motor does not work
fuses burnt
The motor starts
up slowly and does Voltage too low, coils damaged,
not reach operating capacitor burnt
speed.
Motor makes exces-
Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are over-
reach its full power. loaded (lamps, other motors, etc.)
Motor overheats Overloading of the motor, insuffi-
easily. cient cooling of the motor
Saw cut is rough or Saw blade dull, tooth shape not ap-
wavy propriate for the material thickness
Workpiece pulls
Excessive cutting pressure and/or
away and/or splin-
saw blade not suitable for use
ters
40 | GB
Remedy
Arrange for inspection of the machine by a special-
ist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
www.scheppach.com