RCA RC5210P User Manual page 63

Troubleshooting
DVD Problem
Subtitle and/or audio
language is not the one
selected from the
initial setting
No on-screen display
The menu is displayed in a
a foreign language
Play doesn't begin when
a title is selected
No forward or reverse scan
Disc won't play
Desired angle cannot be changed
Picture is not displayed
with correct aspect ratio
Forgot Rating Limit Password
Cannot copy discs to video tape
Self-Diagnostic Message
U 11
H
Solution
If the subtitle and/or audio language does not exist on the disc, the
initial settings will not be seen/heard. The disc's priority language is selected
instead. Set the subtitle and or audio language initial setting manually.
The OFF setting is selected for OSD Display; select ON in the Setup menu.
The Menu Language preference is set to that language. Go to the
Setup menu and select the language you prefer.
The rating limit has been set and the disc is subject to that restriction.
Some DVDs have sections that prohibit rapid scanning, or title and chapter skip.
Both the player and the DVD is coded by region. If the regional codes don't
match, the disc cannot be played. This player is Region No. 1.
Some DVDs do not have the multi-camera angle system, and some discs have it
only on certain portions.
Make sure the TV SCREEN feature in the Setup menu is set correctly for your
television.
With the power on, press and hold the SKIP REV, PAUSE, and POWER buttons on
the player. This resets the password feature and all other settings to the initial
factory settings. You may be required to select a menu language the next time
you power up.
This player is equipped with anticopy protection.
Solution
The disc is dirty. Wipe the discs with a soft cloth.
When you see a code that begins with "H", it means that the unit
is not functioning properly. Turn the unit off and on again by pressing
POWER twice or unplug the AC power cord from the wall outlet,
and then plug the unit back in. This will make the unit operate
normally if external electrical influences such as lightning or static
electricity have affected the operation of the unit.
Troubleshooting
Reference 61