Emptying The Water Tank - Sharp DW-208EX Operation Manual

Emptying the Water Tank

Emptying the Water Tank
If the water tank fills to a level of approx. 5.7 liters, the operation stops automatically. Then an elec-
tronic beep sound will be emitted for 8 seconds, and the "full" indicator light will blink showing that the
water tank is full. Empty the tank as shown below.
1
Remove the water tank.
Open the front door, pull out the tank by pushing up
the tank handgrip a little and take the tank out care-
fully by holding it with both hands. The tank weighs
about 6.6 kg when it is filled up to the limit. Be careful
to avoid getting injured when taking it out.
Empty the water tank.
2
The drainage tank can be carried by holding the
tank handle.
Empty the water tank, clean the tank and wipe
off excess water outside the tank.
If water remains on the float, the automatic stop
function of the dehumidifier will not work
properly. So make sure to wipe away the water
from the float.
Put in the water tank.
3
(1) Make sure "Tank lid" fits securely in the outer of the tank.
(2) Put the water tank firmly into the unit until it touches
the back of the unit.
How to detach and install the tank lid and
float
(1) Detach the tank lid gradually from the left or right
toward the opposite side.
(2) As shown in the diagram, push the float into the
"1" direction and remove it from the hole.
(3) Draw the float out in the "2" direction while push-
ing it as it is.
(4) When attaching it, install it properly into the origi-
nal position in reversing the procedures ("2" to "1").
Make sure to push the float in the
tank. Otherwise water might spill
in the unit or operation cannot
stop when the tank is filled up to
the limit. Do it carefully.
Cautions
Do not remove the water tank immediately after the unit is turned off.
Otherwise water remaining in the cooling device may drip inside the unit.
(If any water spills, wipe it off with a soft cloth. )
Do not touch anything inside the unit after the water tank is removed.
(Otherwise when the tank is full, the automatic stop function may not work
properly.)
Before moving the unit, make sure to turn it off and drain the water
from the tank.
Otherwise water may spill out onto the floor.
16
Water tank
Tank handle
Tank lid
Fix the tank
lid firmly into
the ditch.
The lever of the
float must be put
over the tank lid.
The rotation must
be smooth.
When taking out the water tank, the
front full tank green lamp will light up,
the FULL tank indicator on the liquid
crystal display will start to blink, and
the unit stops its operation.
Handgrip
1
Water tank
Float
2
At low temperatures, water may
freeze in the unit's cooling sys-
tem instead of collecting in the
water tank. Note that this is not
a sign of failure.
Float