Advertisement
Available languages
Available languages
Where appropriate, the analyzer also sends the following messages with a time stamp (HH : MM :
SS):
Cleaning
Stopped
Fix-time
Standby
AUTO SYS CAL
PROCESS SYS CAL
MANUAL SYS CAL
LEVEL SAMPLE
OVER TITR TIME
ERROR CALIB
LEVEL REAGENT
Titration reagent missing
LEVEL COND
Conditioning reagent missing
LEVEL CALIB
Calibration solution missing
LEVEL CLEANING
Cleaning solution missing
RETURN PROCESS After an external sample measurement, this message indicates a return to process
measurement
SLOPE CALIB 1/2
Automatic calibration error
5.5 Additional accessories
Any accessories that have been purchased but that have not been factory installed, can be installed
now. Instructions for the installation and wiring are given in the full user manual.Once everything has
been installed, check the following in the measurement chamber:
• Nothing is in contact with the stirrer
• The upper part of the overflow pipe is about 2 cm above the siphon
• The level detector is about 1 cm below the bottom of the siphon inlet
• If not connected, connect the measuring electrode to the thicker cable and the reference electrode
to the thinner cable.
Section 6 User interface
6.1 Front panel description
The interface is via a 4-key keyboard, a 4-digit numeric display and an alphanumeric display of 2-
lines of 16 characters.
18 English
ACTIONS
Chemical cleaning
Analyzer stopped
Time between two cycles
Analyzer in standby
Automatic calibration
Process calibration
Manual calibration
SYSTEM ERRORS
Sample missing from measuring cell
Titration time is too long
Automatic calibration error
WARNINGS
Advertisement
