Table of Contents
Advertisement
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows. Do not place loop handle or suspension ring
on label.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
on page 17 .
WARNING:
cutting attachment can result in injury or
death.
1857 - 004 - 02.06.2023
Assembly
Use protective gloves.
Always use the cutting
Technical data
An incorrectly attached
To attach the cutting attachment guard
1. Attach the cutting attachment guard (A) to the hook
on the plate holder (B).
B
A
2. Install the cutting attachment guard on the shaft and
tighten it with the bolt (C).
To remove the cutting attachment guard
•
Loosen the bolt (C) and remove the cutting
attachment guard (A) from the shaft.
A
Assembly of trimmer heads
WARNING:
cutting attachment it is very important that
the raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If you install the
cutting attachment incorrectly, it can result in
serious and/or fatal personal injury.
WARNING:
attachment without an approved guard.
Accessories on page 18 . If an
Refer to
incorrect or faulty guard is fitted, this can
cause serious personal injury.
C
C
When you install the
Never use a cutting
11
Advertisement
Table of Contents
