Lighting The Appliance (Remote Control Models) - Flavel Calypso Installation, Maintenance & User Instructions

3.7 LIGHTING THE APPLIANCE - REMOTE CONTROL MODELS
(CONTINUED)
3.7.3 To decrease the heat input level of the burner hold the handset as
described in section 3.7.1 to unlock the keypad then press and
release the - button. Pressing and releasing the - button will lower the
heat input level one step at a time. Pressing the - button continuously
will move the heat input level to the minimum.
3.7.4 To increase the heat input level of the fire's burner hold the handset as
described in section 3.7.1 to unlock the keypad then press and
release the + button. Pressing and releasing the + button will increase
the heat input level one step at a time. Pressing the + button
continuously will move the heat input level to the maximum.
3.7.5 To turn the fire off hold the handset as described in section 3.7.1 to
unlock the keypad then press and release the power button. The
burner will go out.
3.7.6
If you are not intending to use the fire for a long period (i.e.
over the summer months) the battery life can be extended by
sliding the power isolator switch to the left (to the "0" position
away from the "1" position) on the valve itself, which is located
behind the ashpan cover on the fire.
3.7.7 In the event of loss of the remote handset, as a backup the fire can
be controlled from the valve, which is located behind the ashpan
cover on the fire, see section 3.6 for full manual operating
instructions. If your fire does not operate manually please consult
the troubleshooting chart on the rear page of this manual.
3.7.8 If the handset is misplaced you can "page it" by pressing the (+) button
only on the control valve on the fire for a period of 5 seconds. The
handset will flash and make an audible noise to help you locate it.
Once you find the handset with one hand ensure your hand
is wrapped around the back and that your hand is in contact with both
sides of the handset then the audible noise will cease. The flashing
and sound will last for 60 seconds each time the handset is paged as
described. If not found in 60 seconds page the handset again until
located.
32