Configuration; Decorative Panel Setting - Daikin FWF02D Installation And Operation Manual

3 Connect the AC heating and signal cables from the controller to
the X2M terminal.
4 Connect the power supply cables (L, N, Earth) to the lower part
of the X1M terminal as shown in the figure.
5 Connect the L, N and Earth for power supply of the remote
controller to the upper part of the X1M terminal.
FWF02~05D
Fan coil units
3P443944-9T – 2023.01
a
b
6 Cable clamps (c).
7
7

Configuration

7.1

Decorative panel setting

Make the following field settings so that they correspond with the
actual installation setup and with the needs of the user:
▪ Design decoration panel (if applicable)
▪ Air flow direction
INFORMATION
In case the flaps operate automatically:
When the fan starts to operate, the flaps open completely
and then remain in the set position. Check the below table
for appropriate angle settings.
When the fan stops to operate including thermo off, the
flaps open completely and then close completely.
7 Configuration
c
Installation and operation manual
17