Panasonic HC-X2050 Operating Instructions Manual page 87

[CHANNEL]
Sets the channel to be used when connected to the wireless LAN with following items set.
≥ The [NETWORK] menu  [WLAN PROPERTY]  [TYPE]  [DIRECT]
The items that can be set are as follows.
≥ [AUTO], [CH1], [CH6], [CH11]
(Factory setting: [AUTO])
[ENCRYPTION]
Sets the encryption method when the [NETWORK] menu  [WLAN PROPERTY]  [TYPE]  [INFRA(SELECT)]/[INFRA(MANUAL)] is selected.
The items that can be set are as follows.
≥ [WPA-TKIP], [WPA-AES], [WPA2-TKIP], [WPA2-AES], [NONE]
(Factory setting: [WPA2-AES])
@ NOTE
0 The setting is fixed to [WPA2-AES] when the [NETWORK] menu  [WLAN PROPERTY]  [TYPE]  [DIRECT] is set.
[ENCRYPT KEY]
Sets the encryption key. Set the key using a string of 8 to 63 characters or a hexadecimal number with 64 digits.
(Factory setting: [01234567890123456789abcdef])
[WLAN IPv4 SETTING]
[DHCP]
Sets whether to use the automatic acquisition through DHCP or to use the DHCP server function of the unit.
[OFF]
[CLIENT]
[SERVER]
(Factory setting: [OFF])
[IP ADDRESS]
Sets the IP address.
(Factory setting: [192.168.0.1])
@
NOTE
0 Cannot be set when [WLAN IPv4 SETTING]  [DHCP]  [CLIENT] is selected.
[SUBNET MASK]
Sets the subnet mask.
(Factory setting: [255.255.255.0])
@ NOTE
0 Cannot be set when [WLAN IPv4 SETTING]  [DHCP]  [CLIENT] is selected.
[DEFAULT GATEWAY]
Sets the default gateway.
(Factory setting: [192.168.0.254])
@
NOTE
0 If you do not use default gateway, set to [0.0.0.0].
0 Cannot be set when [WLAN IPv4 SETTING]  [DHCP]  [CLIENT] is selected.
0 Disables the setting for the default gateway when [WLAN PROPERTY]  [TYPE]  [DIRECT] is selected.
[PRIMARY DNS]
Sets the primary DNS server.
(Factory setting: [0.0.0.0])
@ NOTE
0 Disables the setting for the primary DNS server when [WLAN PROPERTY]  [TYPE]  [DIRECT] is selected.
[SECONDARY DNS]
Sets the secondary DNS server.
(Factory setting: [0.0.0.0])
@
NOTE
0 Disables the setting for the secondary DNS server when [WLAN PROPERTY]  [TYPE]  [DIRECT] is selected.
[INFORMATION]
[STATUS]
Displays the status of the network function.
Chapter 4 Operation — Menu settings
Does not use DHCP.
Performs automatic acquisition through DHCP if connecting by setting [WLAN PROPERTY]  [TYPE]  [INFRA(SELECT)]/
[INFRA(MANUAL)].
Enables the DHCP server function of the unit when connecting by setting [WLAN PROPERTY]  [TYPE]  [DIRECT].
- 87 -