Panasonic HC-X2050 Operating Instructions Manual page 73

[INPUT2 LINE LEVEL]
Sets the audio input level of the audio device connected to the <INPUT 2> terminal. Enabled when the audio device is connected and the <INPUT2>
switch is set to <LINE>.
The items that can be set are as follows.
≥ [4dB], [0dB]
(Factory setting: [0dB])
[MIC SETTING]
This can be set when the handle unit (
[CH1 LEVEL]
Sets if the recording level adjustment method for audio channel 1 is to be automatic or manual.
The items that can be set are as follows.
≥ [AUTO], [MANUAL]
(Factory setting: [AUTO])
[CH2 LEVEL]
Sets if the recording level adjustment method for audio channel 2 is to be automatic or manual.
The items that can be set are as follows.
≥ [AUTO], [MANUAL]
(Factory setting: [AUTO])
[CH1 LEVEL CONTROL]
The recording level can be manually adjusted when [CH1 LEVEL] adjusting the recording level of the audio channel 1 is set to [MANUAL].
The items that can be set are as follows.
≥ [MUTE], [j30dB]...[i12dB]
(Factory setting: [0dB])
[CH2 LEVEL CONTROL]
The recording level can be manually adjusted when [CH2 LEVEL] adjusting the recording level of the audio channel 2 is set to [MANUAL].
The items that can be set are as follows.
≥ [MUTE], [j30dB]...[i12dB]
(Factory setting: [0dB])
[INPUT SETTINGS]
[CH1 MIC LOWCUT]
Switches enable/disable of the lowcut filter for audio channel 1.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[CH2 MIC LOWCUT]
Switches enable/disable of the lowcut filter for audio channel 2.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[CH1 LIMITER]
Switches enable/disable of the limiter when the method to adjust the audio input level for audio channel 1 is manual.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
@ NOTE
0 In the following case, [CH1 LIMITER] is fixed to [ON]:
j When [CH1 LEVEL] is set to [AUTO]
j When the <CH1> switch is set to <AUTO>
[CH2 LIMITER]
Switches enable/disable of the limiter when the method to adjust the audio input level for audio channel 2 is manual.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
@ NOTE
0 In the following case, [CH2 LIMITER] is fixed to [ON]:
j When [CH2 LEVEL] is set to [AUTO]
j When the <CH2> switch is set to <AUTO>
Chapter 4 Operation — Menu settings
/ supplied,
X2000 X1500
X2050
optional) has not been attached to the unit.
- 73 -