Autocalibration Procedure - Promation Engineering P1-12VN4 AC Installation & Operation Manual

AutoCalibration Procedure

Calibration is not
necessary
Actuator may be
put into service
AdVanced Controller
Calibration
Were CW
NO
or CCW End of
Travel cams changed
from factory
settings?
Set DIP 5 to OFF
Use Wire to Jumper
connector pins 7 and 12
Set DIP 1 to ON
Set DIP 5 to ON
4. Blue LED blinks 5 times
5. Blue LED goes off
6. Red LED goes on and motor drives actuator to fully CW
7. The CW End of Travel switch opens and motor stops
8. The Green LED goes on and motor drives to fully CCW
9. The CCW End of Travel switch opens and motor stops
10. Red LED goes on and actuator drives to 50% position
11. The controller performs internal test of the potentiometer position
Page 12 of 14 P1 LV AdVanced Proportional Series
YES
YES
Is power
supplied to the
board?
PWR
PWR
DIAG
DIAG
NO
Wire the actuator per
the wiring diagram
Actuator will start
the Potentiometer
calibration routine: