Table of Contents
Advertisement
Calibration Procedure:
Calibration is not
necessary
Actuator may be
put into service
NOTE: The P1.A
main output drives
90°
indicator/camshaft
rotates 180° in the
opposite direction.
AdVanced Controller
Calibration
NO
or CCW End of
Travel cams changed
from factory
Set DIP 5 to OFF
Use Wire to Jumper
connector pins 7 and 12
Set DIP 1 to ON
Set DIP 5 to ON
4. Blue LED blinks 5 times
5. Blue LED goes off
6. Red LED goes on and motor drives actuator to fully CW
while
the
7. The CW End of Travel switch opens and motor stops
8. The Green LED goes on and motor drives to fully CCW
9. The CCW End of Travel switch opens and motor stops
10. Red LED goes on and actuator drives to 50% position
11. The controller performs internal test of the potentiometer position
Page 12 of 14 P1.A LV AdVanced Proportional Series
Were CW
YES
settings?
YES
PWR
PWR
DIAG
DIAG
NO
Is power
supplied to the
board?
Wire the actuator per
the wiring diagram
Actuator will start
the Potentiometer
calibration routine:
Advertisement
Table of Contents
