Steps
1. Align the screw holes on the USB board with the screw holes on the system board and insert the USB board in to the system
board.
2. Replace the two screws (M2x4) that secure the USB board to the system board.
Next steps
1. Install the
system
board.
2. Install the
memory
module.
3. Install the
wireless
card.
4. Install the
solid-state
5. Install the
rear
cover.
6. Install the battery.
7. Install the
base
cover.
8. Follow the procedure in
I/O board
Removing the I/O board
Prerequisites
About this task
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state
6. Remove the
wireless
card.
7. Remove the
memory
module.
46
Removing and installing components
drive.
After working inside your
Before working inside your
drive.
computer.
computer.