Rear Cover - Dell G15 5520-4132 Service Manual

Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly
NOTE: If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
2. Connect the speaker cable to the system board and route the cable below the USB board .
3. Adhere the speaker cable to the palm-rest and keyboard assembly.
4. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE: Route the speaker cable below the USB board (LAN board). Do not route the speaker cable over the solid-state
drive bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in

Rear cover

Removing the rear cover
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
The following image indicates the location of the rear cover and provides a visual representation of the removal procedure.
28 Removing and installing components
After working inside your
Before working inside your
computer.
computer.