3. Replace eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
4. Turn the display assembly over.
5. Connect the camera cable to the system board.
6. Connect the display cable to the connector on the system board and close the latch to secure the cable.
7. Adhere the tape that secures the display cable to the system board.
8. Route the antenna cables through the routing guides on the fan and adhere the tape that secures the antenna cables to the
system board .
Next steps
1. Install the
wireless
card.
2. Install the
rear
cover.
3. Install the
base
cover.
4. Follow the procedure in
Power button
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state
6. Remove the
wireless
card.
7. Remove the
memory
module.
8. Remove the
system
board.
NOTE:
System board can be removed with the fan and heat-sink assembly, I/O board, and USB board attached.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
34
Removing and installing components
After working inside your
Before working inside your
drive.
computer.
computer.