Table of Contents
Advertisement
Updating the GoVault Firmware
GoVault™ for Windows User's Guide
Check and update the firmware on the GoVault dock as follows:
1 Use the procedure in
Status
to view the GoVault
2 Note the
Revision
column on the
Status
3 To determine the most-recent revision level of the GoVault firmware,
use your Internet connection to open the Quantum web page at:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/GoVault/Index.aspx#Firmware
4 Compare the most-recent revision of the GoVault firmware on the
Quantum website with the version that is installed on your dock:
a If they are the same, then there is no need to proceed with the
firmware update procedure.
b If the firmware on the Quantum website is a later version than
the firmware installed on your dock, then download the newer
firmware file, saving it to a location on your local system startup
hard drive. This is usually drive C.
5 Insert a write-enabled cartridge into the GoVault dock.
6 Click
Update Firmware
dialog (see
Update
7 Click
Browse for Firmware File
you downloaded and saved in step 4-b of this procedure.
8 With the new firmware file displayed in the
field, click
Start Update
9 As prompted by the
(see
figure
30), close all open applications that might try to
communicate with the GoVault drive, including:
•
Any third-party backup software
•
Windows
Explorer
•
My Computer
Checking the GoVault Dock and Cartridge
display (see
Status
level shown for the GoVault dock in the
display.
on the
display to view the
Status
figure
29).
and navigate to the new firmware file
.
Ready to commence firmware update
Chapter 3 Operation
Updating the GoVault Firmware
figure
28).
Dock
Firmware
Enter Firmware Filename
message
47
Advertisement
Table of Contents
