Table of Contents
Advertisement
Installing the External GoVault Tabletop Dock
Figure 10 GoVault Tabletop
Rear Panel
GoVault™ for Windows User's Guide
Install the external GoVault Tabletop dock and cartridge as follows:
1 Connect the drive-end (Mini-B) connector of the USB interface cable
to the Mini-B USB port on the rear panel of the GoVault Tabletop
dock (see
figure
10).
2 Connect the DC power output plug of the power adapter/converter
to the DC power jack on the rear panel of the dock.
3 Carefully position the dock in a secure location that provides
adequate circulation for the rear panel air vents (see
4 Plug the power adapter/converter into a 115/230 VAC facility power
receptacle and verify that the LED on the front panel of the GoVault
Tabletop dock illuminates.
Air vents
5 Connect the system-end (standard) connector of the USB interface
cable to an available USB port on your workstation or server system
and verify that the system launches the
that finds and configures the device driver, assigns a drive letter, and
enables read/write access.
6 Use Windows
My Computer
configuration (see
Chapter 2 Installation Procedures
Installing the External GoVault Tabletop Dock
Mini-B USB port
to verify successful GoVault Tabletop
figure
9).
figure
10).
DC power jack
Found New Hardware
wizard
15
Advertisement
Table of Contents
