Table of Contents
Advertisement
Installing the Internal GoVault Dock
Installing the SATA Card
GoVault™ for Windows User's Guide
3 Visually inspect the GoVault dock and notify your Quantum
representative immediately of any damage.
4 Always save the shipping container and packing materials for any
future use.
To install the internal GoVault dock and cartridge disk drive, complete
the following procedures in the order presented:
•
Installing the SATA
•
Installing the Internal GoVault Dock
If your workstation or server system does not already have either a
2
SATA-equipped motherboard or a SATA-compliant host bus adapter PCI
card, you should follow the procedures provided by the manufacturer of
the SATA card and your computer reference manual.
If the procedures presented in this subsection do not appear to be
appropriate for your workstation or server system, stop the installation
attempt and seek assistance from the appropriate hardware
manufacturer.
Note:
This procedure is only necessary if your workstation or server
system does not already have a SATA-equipped motherboard
or a SATA-compliant host bus adapter PCI card installed.
Procedure
1 As required:
a Save and close your open files and terminate all running
applications.
b Shut down the workstation or server system.
c Disconnect the AC power cord from the facility AC power
receptacle.
Chapter 2 Installation Procedures
Installing the Internal GoVault Dock
Card, if required
2
9
Advertisement
Table of Contents
