Mitsubishi Electric FR-S540E-0.4K-EC Instruction Manual page 24

4.3.2 Example: Changing the Pr. 30 setting from "0" to "1"
(The extended parameters are made valid by setting "1" in Pr. 30 "extended function
display selection". Refer to page 32 for the extended function parameter list and to the
instruction manual (detailed) for details.)
Operation
Confirm the RUN indication and
1.
operation mode indication.
The inverter must be
at a stop.
The inverter must be
in the PU operation mode.
Press the to choose
MODE
2.
the parameter setting mode.
Turn the until
3.
appears.
4.
SET
Press the to read
the currently set value.
"
" (factory setting) appears.
5.
Turn the to change it to
the set value of " ".
6.
Press the to set
SET
the value.
•
By turning the
•
Press the
•
Press the
After parameter setting is complete, press the
history or twice to return to the monitor display. To change the setting of
another parameter, perform the operation in above steps 3 to 6.
Error display?
REMARKS
If the setting has not been changed, the value does not flicker and the next parameter number
appears.
(Press the
(Pr. 30)
, you can read another parameter.
to show the setting again.
SET
twice to show the next parameter.
SET
• If the operation panel does not have the write precedence
• If write was performed during operation.
• If write was performed in the external operation mode
PU
.)
EXT
MODE
SET
SET
Flicker...Parameter setting complete!!
once to show the alarm
MODE
19
Setting the parameters
Display
RUN
PU
EXT
The parameter
number read
previously
appears.
4