Quantum DLT 1 Interface Manual page 49
Quantum dlt 1: user guide
Hide thumbs
Also See for DLT 1:
- Install manual (4 pages) ,
- User manual (2 pages) ,
- Operation manual (68 pages)
Table of Contents
Advertisement
Table 4-4. Standard Inquiry Data Page — Field Descriptions (Continued)
Field Name
Vendor Identification
Product Identification
Product Revision Level
Vendor Specific
81-81276-01 Rev A01
Description
Byte 7
RelAdr. Set to 0
WBus32. Set to 0 (The tape drive does not support 32-bit
transfer.)
WBus16. Set to 1 (The tape drive supports 16-bit wide data
transfers.)
Sync. Set to 1 (The tape drive supports Synchronous Data
Transfer/
Linked. Set to 1 (The tape drive supports Linked commands.)
CmdQu. Set to 0
SftRes. Set to 0
"QUANTUM"
"VS80
"
This field contains four bytes of ASCII data that define the product's software
Revision Levels. The first two bytes are the version number of servo code. In
Quantum products, this firmware is located in an EEPROM and is field
updateable. The second two bytes are the version number of the SCSI/read/write
code. When a firmware update is performed on the tape drive, this part of the
Revision Level field changes appropriately.
See
"Vendor Unique Inquiry Bytes" on page 4-9
July 2004
DLT1/VS80 SCSI Interface Guide
4-7
Advertisement
Table of Contents
