Quantum DLT 1 Interface Manual page 105

Table 4-37. MODE SELECT EEPROM Vendor Unique Page — Parameter Descriptions
Name
LdrCycleReset
LoaderLUN
LongXportPage
NoDeferRcvdErr
NoDisconFxdBlk
NoRdyUAOnUnld
PerfMode
ProtectDirOnWp
RedundancyMode
RepBusyInProg
ReportRcvdPErrs
ReportRcvRdErr
81-81276-01 Rev A01
Value Rep Default
ASCll 0
Binary
ASCll 1
Decimal
ASCll 1
Binary
ASCll 0
Binary
ASCll 1
Binary
ASCll 0
Binary
ASCll 1
Binary
ASCll 0
Binary
ASCll 1
Decimal
ASCll 0
Binary
ASCll 1
Binary
ASCll 0
Binary
July 2004
Length
(Bytes)
1 When set, causes the first cartridge to be
loaded if unloading the last cartridge when
the loader product is operated in sequential
mode.
1 LUN to report media loader device on. Valid
values are 1 - 7.
1 When set, reports medium transport element
status descriptor (6 bytes or 18 bytes) .
1 When set, the tape drive reports a deferred
recovered error as current recovered error.
1 When set to 0, turn off feature of not to
disconnect on every fixed block data
transfer. When set to 1, turns on this feature.
1 When set, removes Not Ready to Ready
Unit Attention from the Unit Attention
queue upon a successful unload.
1 When set to 0, the tape drive is tuned for
capacity.
When set to 1, the tape drive is tuned for
performance.
1 When set, protects tape directory if the
cartridge write-protect switch is in write
protect position.
1 Sets the value of the allowed maximum
marginal channel (0-3 allowed).
1 When set to 1, reports BUSY status if the
tape drive is in the process of becoming
ready.
1 When set, reports recovered error if parity
error has been retried successfully.
1 Sets the default value of PER bit of Read /
Write Error Recovery Mode page (01h).
DLT1/VS80 SCSI Interface Guide
Usage
4-63