Quantum DLT 1 Interface Manual page 104

Chapter 4: SCSI Commands
Table 4-37. MODE SELECT EEPROM Vendor Unique Page — Parameter Descriptions
Name
DisDRAutoLDMC
DisUnbufMode
EnaClngLTRPT
EnaInitSyncNeg
EnaLdrAutold
EnaModePg22
EnaParErRetry
EnaRepDecomp
EnaThirdPtyDens
EnbInqMedChgr
ForceComp
ForceDensity
ForceEERebuild
ForceReadSILI
4-62
Value Rep Default
ASCll 1
Binary
ASCll 0
Binary
ASCll 1
Binary
ASCll 0
Binary
ASCll 1
Binary
ASCll 0
Binary
ASCll 0
Binary
ASCll 0
binary
ASCll 1
Binary
ASCll 0
Binary
ASCll 0
Binary
ASCII 1
Decimal
ASCll 0
Binary
ASCll 0
Binary
July 2004
Length
(Bytes)
1 When set, partially disables sequential
loading with loader if any media loader
command has been received.
1 When set, the tape drive disables unbuffered
mode; that is, the tape drive ignores the
MODE SELECT "buffered mode" selection
to turn off buffered mode.
1 When set, reports error status (if cleaning
indicator is on).
1 When set, enables target initiated
synchronous negotiation.
1 When set, turns on/off sequential loading
with loader.
1 When set, enables vendor unique data
compression (Status Mode Page).
1 When set, turns on/off parity error retry
feature.
1 If set and the tape drive is in Read mode, the
decompression algorithm field in Data
Compression Mode page will reset if the last
block requested by the host was
decompressed, otherwise it is cleared.
1 When set, makes non-DLT density code act
as the default density (same as density
code).
1 When set to 0, disables media changer bit.
When set to 1, enables media changer bit in
byte 6 of INQUIRY data.
1 0=Automatic
1=Always compress
1 0=Automatic
1=DLT
1 When set, forces all the EEPROM
parameters reset to default.
1 When set, handles variable READ
command as if the SILI bit is set.
Usage
81-81276-01 Rev A01