Quantum DLT 1 Interface Manual page 31
Quantum dlt 1: user guide
Hide thumbs
Also See for DLT 1:
- Install manual (4 pages) ,
- User manual (2 pages) ,
- Operation manual (68 pages)
Table of Contents
Advertisement
DLT1/VS80 SCSI Interface Guide
Bus parity errors cause the tape drive to retry the operation, go to STATUS phase, or go to BUS FREE
and prepare Sense Data (see section 6.1.1 in the SCSI-2 specification). Retrying of parity errors during
DATA OUT Phase when writing is normally not done, but can be enabled by changing the
EnaParErrRetry parameter in the Vendor Unique EEPROM Mode Page. The default value for this
feature is parity error disabled.
81-81276-01 Rev A01
July 2004
2-7
Advertisement
Table of Contents
