Toyotomi KS-47 Operation And Maintenance Instruction page 7

ASSEMBLY AND OPERATlON
ASSEMBLY AND OPERATlON
lNSPECTlON AND ASSEMBLY
lNSPECTlON AND ASSEMBLY
NOTE: Save the shipping carton and packing materials for future storage of your heater.
NOTE: Save the shipping carton and packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
1. REMOVE PACKING MATERIALS
Remove all packing materials from your heater and install the guard as follows:
Remove all packing materials from your heater and install the guard as follows:
CAUTION: Risk of fire. The packing materials are flammable.
CAUTION: Risk of fire. The packing materials are flammable.
a) Remove the carrying handle, top plate and packing materials. a) After removing the top plate, take the packing materials out of the outer cover.
a) Remove the carrying handle, top plate and the packing materials.
b) Place the top plate and install carrying handle by inserting end of carrying handle to b) Put the top plate back on the top of the outer cover.
b) Place the top plate and install carrying hadle by inserting end of carrying
the guard as per illustration.
handle to the guard as per illustration.
2. INSTALL DRIP TRAY
2. INSTALL DRIP TRAY
NOTE: DO NOT operate your heater without the drip tray.
NOTE: DO NOT operate your heater without the drip tray.
Place the drip tray on the floor.
Place the drip tray on the floor.
● Place the heater on the drip tray so the three (3) legs of the heater are next to the three
Place the heater on the drip tray so the three (3) legs of the heater are next to the three
(3) tabs on the tray.
(3) tabs on the tray.
● Turn the heater clockwise until the feet slide into their tabs.
Turn the heater clockwise until the feet slide into their tabs.
3. INSTALL BATTERIES
3. INSTALL BATTERIES
Locate the battery holder on the back of your heater. Remove the battery holder cover.
Locate the battery holder on the back of your heater. Remove the battery holder cover.
● Insert the four (4) "C" size batteries according to the plus (+) and minus (–) markings
Insert the four (4) "C" size batteries according to the plus (+) and minus (–) markings
inside the holder.
inside the holder.
4. CHECK SCREWS
4. CHECK SCREWS
Make sure that three (3) screws around the outer cover assembly above the fuel tank are
Make sure that three (3) screws around the outer cover assembly above the fuel tank are
tight.
tight.
6
6
Top plate
Outer
cover
Packing
material
Fuel tank
Fuel tank
Tab Tray
Tab Tray