Epson S5U13L01P00C100 User Manual page 16

Chapter 4 Connectors
Note
The SPI interface is not available when the S5U13L01P00C100 evaluation board is used with the
S5U13U00P00C100 USB adapter board.
The S5U13U00P00C100 USB adapter board supplies the 5V power required by the S5U13L01P00C100 evaluation
board. The S5U13L01P00C100 evaluation board then supplies the IOVDD for the S5U13U00P00C100 USB
adapter board. Therefore, both JP102 on the S5U13L01P00C100 evaluation board and JP1 on the
S5U13U00P00C100 USB adapter board should be set to position 1-2.
When the S5U13L01P00C100 is connected to the S5U13U00P00C100 USB Adapter board, there are 2 LEDs on
the S5U13L01P00C100 which provide a quick visual status of the USB adapter. HB (D300) blinks to indicate that
the USB adapter board is active. ENUM (D301) turns on to indicate that the USB has been enumerated by the PC.
The following diagram shows the location of connectors P1 and P2. P1 and P2 are 2mm x 2mm, 40-pin headers
(20 x 2) located on the underside of the board.
For the pinout of connectors P1 and P2, see Section Chapter 7, "Schematic Diagrams" on page 22.
Note
A windows driver must be installed on the PC when the S5U13L01P00C100 is used with the S5U13U00P00C100
USB Adapter Board. The S1D13xxxUSB driver is available at vdc.epson.com.
16
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 4-2: USB Adapter Connector Locations (P1, P2)
EPSON S5U13L01P00C100 Evaluation Board User Manual (Rev. 1.0)