Table of Contents
Advertisement
INSTALLING THE CHANNEL STOPPER
For transceivers with less than 6 channels, insert a Channel
stopper.
1 Set the Channel selector to channel , then pull the Channel
selector knob off the transceiver.
•
If the Channel selector is not positioned at channel , the
Channel selector knob may not install correctly and the channel
may be unable to be changed.
2 Insert the channel stopper.
3 Set the arrow of the Channel stopper to the highest channel
number for the transceiver.
•
You can set the Channel stopper position for channels , 4, 6,
8, 0, , and 4.
4 Reinsert the Channel selector knob.
INSTALLING THE (OPTIONAL) ANTENNA
Antenna
PREPARATION
Screw the antenna into the connector on
the top of the transceiver by holding the
antenna at its base and turning it clockwise
until secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/ microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade
your transceiver's performance.
Channel stopper
Arrow
Advertisement
Chapters
Table of Contents
