Table of Contents
Advertisement
1 Turn the Power switch/ Volume control clockwise to switch
the transceiver power ON.
•
A beep sounds if enabled by your dealer.
2 Press the key programmed with the [Monitor] or [Squelch
Off] function to hear background noise, then rotate the
Power switch/ Volume control to adjust the volume.
3 Rotate the Channel selector to select your desired channel.
•
When you receive an appropriate signal, you will hear audio
from the speaker.
4 To make a call, press and hold the PTT switch, then speak
around the microphone area using your normal speaking voice.
•
Hold the microphone approximately . inches (3 to 4 cm) from
your lips.
5 Release the PTT switch to receive.
Note: When the battery pack voltage becomes too low, transmission
will stop and an alert tone will sound.
LED Indicator Status
Indicator Color
Lights red
Lights green
Blinks red
Blinks green
Blinks orange/
blue
*
Blinks red/orange
* Your dealer can set the LED to blink either orange or blue for
FleetSync, DTMF, or -tone operation.
BASIC OPERATIONS
Transmitting
Receiving a call
Battery power is low while transmitting
Scanning
Receiving an encoded call (FleetSync
signaling, etc.)
The selected channel has not been
programmed and cannot be used.
Meaning
Advertisement
Chapters
Table of Contents
