Direction Setup; Preset; Scan - Q-See QSIPO26X Operation Manual

4.4.1 Direction Setup

4.4.1.1 Speed
It is to control direction. The value ranges from one to eight.
Please use the number buttons of the keyboard to input value
(between 0~8) and press ENTER to confirm. (Operation here is
only active with key-press. You can use joystick to control
directly. ) Note: for joystick use, the speed is related to the
joystick move range. If the farther the joystick away from the
center, the swifter the PTZ moves.
PTZ movement direction
• For joystick: up/down/left/right/up left/right down/up right/left down.
• For keyboard: up/down/left/right
4.4.1.2 Zoom/focus/Iris
• Zoom: please use WIDE and TELE to control PTZ zoom.
• Focus: please use FAR and NEAR to control PTZ focus.
• Iris: Please use CLOSE and OPEN to control PTZ aperture.
For joystick: clockwise to zoom out and anti-clockwise to zoom in.

4.4.2 Preset

4.4.2.1 Preset setup
After zoom and PTZ setup, input value and click ENTER to
confirm. Now you have set one preset.
4.4.2.2 GOTO
Move cursor to highlight GOTO.
Input preset value and click ENTER.
System goes to specified preset.
4.4.2.3 REMOVE
Move cursor to highlight REMOVE. Input preset value and click ENTER.
Now you have removed one preset.
Note: Some protocols do not support remove preset function. You can modify
to replace the previous one.
4.4.3

Scan

4.4.3.1 Scan setup
I nput value and then move cursor to highlight left limit.
、
Or you can use joystick to move camera to left limit and then
click ENTER.
、 R epeat procedure one to set right limit.
M ove cursor to highlight speed. Input speed value and click
、
ENTER to confirm.
4.4.3.2 Scan operation
U se up/down to highlight scan. Input scan value and click
、
ENTER to begin scanning.
：
Speed 5
〈 Z oom 〉
〈 〉 〈 〉
Preset setup ＞ v alue ： 1
GOTO
Remove
Preset setup ＞ V alue ： 1
GOTO
Remove
Scan Value ： 1
Scan setup ＞ L eft limit
：
Scan Value 1
Scan setup ＞ Begin
Scan Value ： 1
Scan setup ＞ start
31
Versatile scan Stop