Advertisement
Quick Links
3M
Locator Plate 3443-112
™
3M
Platens 3442-44, 3442-1A
™
Instructions for the assembly of 3M
Connectors 8250 and 8350
1.0
General
3M manual and pneumatic assembly presses and accessory assembly equipment are recommended for
the termination of 3M
time, to provide easier and faster assembly and to help reduce assembly error. The 3M Locator Plate
3443-112 and 3M Platen 3442-44 were designed to assemble the D Sub Connector 8250. The Locator
Plate 3443-112 is used with the 3M
Connector Part
Locator Plate Number
Number
8250
*3443-112
8350
*3443-112
*Included with the Locator Plate 3443-112 is a Platen 3442-44. The Platen 3442-44 can also be purchased separately.
April 2010
78-9101-0518-4-A
D Sub Connectors. 3M assembly equipment is offered to help reduce set-up
™
Platen 3443-1A to assemble the D Sub Connector 8350.
™
Platen Part Number
3442-44
3442-1A
D Sub
™
3436-1F Shut Height Setting
Assembly Presses
Assembly Presses
3640/3316
3335/3339-1
15
15 1/2
20
20 1/2
Assembly Press
3830
3830
Advertisement
Related Manuals for 3M 3443-112
Summary of Contents for 3M 3443-112
- Page 1 Assembly Presses Assembly Presses Number 3640/3316 3335/3339-1 8250 *3443-112 3442-44 15 1/2 3830 8350 *3443-112 3442-1A 20 1/2 3830 *Included with the Locator Plate 3443-112 is a Platen 3442-44. The Platen 3442-44 can also be purchased separately. April 2010 78-9101-0518-4-A...
- Page 2 ™ Procedures for Adjusting Shut Height The shut height should be adjusted from the base before the locator plate is put into place. The 3M ™ Assembly Presses 3316 and 3640 are adjusted with a knob at the top of the press. The 3M Assembly ™...
- Page 3 Install the 3M Locator Plate and the ™ appropriate platen on the assembly press. The platen should be positioned parallel with the connector body and cover. Note: See the chart on page 1 for shut height settings. Figure 4: 3M Assembly Press 3335 ™...
- Page 4 Since these factors are uniquely within the user’s knowledge and control, it is essential that the user evaluate the 3M product to determine whether it is fi t for a particular purpose and suitable for the user’s application.
Need help?
Do you have a question about the 3443-112 and is the answer not in the manual?
Questions and answers