Related Manuals for 3M 3443-81 Series
Summary of Contents for 3M 3443-81 Series
- Page 1 Instruction Guide March 2022 78-9102-1086-9_C 3M Instruction Guide: 3M Locator Plate 3443-81-XX, 3D-Printed Instructions for the assembly of 3M Ribbon Cable Wiremount Socket Assembly, 451 Series P a g e 1 | 8...
-
Page 2: Procedures For Set-Up
3M Instruction Guide: 3M Locator Plate 3443-81-XX, 3D-Printed General The assembly of 3M Ribbon Cable Wiremount Socket Assemblies, 451 Series, 0.050” x 0.050” sockets and 3M Round Conductor Flat Cable 0.025” can be accomplished when using the 3M Locator Plates. 3443-81-XX Series; 3D- Printed Base Plate 3443-81-00;... - Page 3 The Shut height should be adjusted from the base before the locator plate is put into place. The 3M Assembly Presses 3316 and 3640 are adjusted with a knob at the top of the press. The 3M Assembly Press 3335 is adjusted with the collar on the press shaft, and the 3M Assembly Press 3830 is self-adjusting.
- Page 4 3M Instruction Guide: 3M Locator Plate 3443-81-XX, 3D-Printed Install the 3M base plate, and appropriate locator plate insert on the press. (See Figure 5) Add platen by positioning it parallel with the connector body and cover. (See Figure 9) Figure 5 Procedures for Cable Preparation Before assembly of the connector can take plate, the cable must be prepared.
- Page 5 3M Instruction Guide: 3M Locator Plate 3443-81-XX, 3D-Printed Procedures for Cable Termination After the cable is prepared it is ready for termination. Place the socket connector onto the cover over the cable, verifying the pin 1 indicator is in the correct position. (See Figure 8) Figure 8 Bring the handle of the press down until the IDC’s press into cable and the...
- Page 6 3M Instruction Guide: 3M Locator Plate 3443-81-XX, 3D-Printed Figure 10 (Metal fixture shown) Strain Relief Attachment Fold the cable back over the cover. (See Figure 11) Figure 11 Place the strain relief in the connector over the cable, sliding the strain relief into the slots of the connector.
- Page 7 3M Instruction Guide: 3M Locator Plate 3443-81-XX, 3D-Printed Press the strain relief down until the strain relief snaps into the correct position on the connector. (See Figure 13) Figure 13 P a g e 7 | 8...
- Page 8 Product Use: Many factors beyond 3M’s control and uniquely within user’s knowledge and control can affect the use and performance of a 3M product in a particular application. Given the variety of factors that can affect the use and performance of a 3M product, user is solely responsible for evaluating the 3M product and determining whether it is fit for a particular purpose and suitable for user’s method...