Table of Contents
Advertisement
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
12.1 Detaching the Roll Over Box Blade from Tractor
Lower the implement to the ground with rockshaft control in position control. Remove top link from mast,
disconnect hitch arms from bottom pins and pull tractor away from implement.
13. BLADE AND STORAGE
Properly preparing and storing the blade and rake at the end of the season is critical to maintaining its
appearance and to help ensure years of dependable service. The following are suggested storage procedures:
•
Thoroughly clean all debris off the unit to prevent damage from rotting grass and standing water.
•
Lubricate all grease points as detailed in the maintenance section.
•
Tighten all bolts and pins to the recommended torque.
•
Check the unit for worn and damaged parts. Perform repairs and make replacements immediately so that
the unit will be ready for use at the start of the next season.
•
Store the unit in a clean, dry place resting securely on the level ground.
•
Use spray touch-up enamel where necessary to prevent rust and maintain the appearance of the unit.
Never allow children to play on or around Tractor or Implement. Children can slip or fall off
the Equipment and be injured or killed. Inadvertent contact with controls can cause the
Implement to shift or fall crushing themselves or others.
14. TRANSPORTING THE TRACTOR AND IMPLEMENT
Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind
when you finish working in an area. Therefore, the operator must employ good judgement and safe operation
practices when transporting the tractor and implement between locations. By using good judgement and
following safe transport procedures, the possibility of accidents while moving between locations can be
substantially minimized. OPS-U- 0017
This Implement may be wider than the Tractor. Be careful when operating or transporting
this equipment to prevent the Implement from running into or striking sign posts, guard rails,
concrete abutments or other solid objects. Such an impact could cause the Implement and
Tractor to pivot violently resulting in loss of steering control, serious injury, or even death.
Never allow the Implement to contact obstacles.
ROLL OVER BOX BLADE 09/20
© 2020 Alamo Group Inc.
OPERATION
(S3PT-15)
Operation Section 3-18
(SG-25)
(S3PT-12)
Advertisement
Table of Contents
