Shutting Down The Implement; Disconnecting The Blade From The Tractor - Bush Hog RO-840 Operator's Manual

OPERATION
If the implement is to be used for back filling, lower the scarifiers to the ground, pull the lever, and back to
tractor to position the back blade for latching (Figure Ops-2018). To use as a box blade, use the same
procedure except pull forward to position the blade.
NOTE: Tool selection lever may have to be altered by lengthening, shortening or bending, to be properly
positioned for your particular tractor.
Care should be exercised during use of the roll over box blade to prevent hanging the scarifier points or the
blades on immovable objects or otherwise use the implement under conditions beyond its designed capacity.

11. Shutting Down the Implement

To shut down the implement, first bring the tractor to
a complete stop.
Park the tractor on a level surface, place the
transmission in park or neutral and apply the
parking brake, lower the attached implement to the
ground, shut down the engine, remove the key,
before exiting the tractor.

12. DISCONNECTING THE BLADE FROM THE TRACTOR

Before disconnecting the blade, all movement must cease. Move the blade to a level storage location and
lower the unit to the ground. If the blade is not resting securely on the ground, block the blade up securely
before attempting to disconnect it from the tractor.
Use extreme care to keep feet and hands from under the blade and clear of any pinch points. OPS- 0051_A
ROLL OVER BOX BLADE 09/20 Operation Section 3-17
© 2020 Alamo Group Inc.