Clutch Lever - Yamaha SCR 950 Owner's Manual

Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to " ", and then slide
the switch toward " ". See page 5-1
for starting instructions prior to starting
the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU12461
" Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
". When ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12501
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU68270
/ " gine not running, otherwise the bat-
tery may discharge.
"SELECT" switch
This switch is used to perform selec-
tions in the odometer and tripmeters
and to set the clock of the multi-func-
tion meter unit.
See "Multi-function meter unit" on
page 3-5 for detailed information.
Instrument and control functions
EAU12735

Clutch lever

" posi-
ECA10062
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
EAU55701
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-16.)
3-8
EAU12822
1
3