Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below. If you subscribe
to high-speed Internet service (DSL - digital subscriber line) through your
telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for
more information about DSL filters.
The telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, see Wall-mount installation on pages 10-12 for details.
Plug the large end of
the base power adapter
into an electrical outlet
not controlled by a wall
switch.
Route the cords
through the slots.
Plug the small end of the
base power adapter into
the power jack on the
bottom of the telephone
base.
Plug the large end
of the charger's
power adapter into
an electrical outlet
not controlled by a
wall switch.
Ensure the small
end of the charger's
power adapter is
plugged into the
power jack on the
bottom of the
charger.
IMPORTANT INFORMATION
Use only the power adapter(s) supplied
with this product. To order a replacement
power adapter, visit our website at
www.telephones.att.com
1 (800) 222-3111
1 (866) 288-4268
6
Plug one end of the
telephone line cord into a
telephone wall jack.
A DSL filter (not included)
is required if you have
DSL high-speed Internet
service.
Plug the other end of the
telephone line cord into
the telephone line jack
on the bottom of the
telephone base.
or call
. In Canada, dial
.