Table of Contents
Advertisement
non-Plug and Play adapter cards, set this parameter to Manual. This allows
you to assign resources to non-Plug and Play cards first.
Integrated Peripherals
This section page includes all the items of IDE hard drive and Programmed
Input / Output features.
Also included in this menu are items for enabling or disabling the onboard
controller chipsets.
Onboard Floppy Disk Controller
This parameter allows you to enable or disable to onboard floppy disk
controller chipset. When set to Enabled, the controller enables the diskette
drive on your computer. When set to Disabled, the controller deactivates the
drive but simultaneously frees IRQ to another device.
Serial Port
Your computer comes with a 9-pin serial port. This parameter displays the
current address for serial port. The default setting Base Address is 3F8.
Parallel Port
Your computer comes with one parallel port. This parameter shows the
default Enabled to activate the parallel port. The default base address is 378.
The default mode is ECP. The default DMA is 3.
Onboard USB
This parameter allows you to enable or disable the universal serial bus (USB)
controller. The default setting is Enabled.
USB / Keyboard Mode
This parameter enables or disables the use of a USB keyboard outside of
Windows. The default is Disabled.
1-16
Advertisement
Table of Contents
