Hilti Nuron SSH 6-22 Operating Instructions Manual page 31

1. Remove the securing screws and remove the cutting rails. If necessary, insert a suitable tool through the
cutting head from above and push the cutting rails out of the guide.
2. Clean the thread.
3. Check the cutting rails:
▶ If the cutting rails are blunt along only one half, reinstall them turned through 180°.
▶ When either one of the two cutting rails is blunt along both halves, replace the two cutting rails as a
pair.
4. Insert the cutting rails and install the securing screws.
Technical data
Tightening torque
5.8 Changing the cut-off plate
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
CAUTION
Risk of damage to product and cutting tools!
▶ Clean the threads before installing the securing screws.
▶ Always use the new securing screws supplied and tighten the screws to the specified tightening torque.
1. Remove the securing screw and remove the cut-off plate.
2. Clean the thread.
3. Insert the new cut-off plate and install the new securing screw.
Technical data
Tightening torque
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶ The motor runs.
3. Lock the on/off switch.
6.2 Cutting 5
Before starting work, check that the cutting rails and the cut-off plate are correctly and securing seated
and check the tightening torques of the corresponding securing screws.
1. Switch the tool on. → page 25
2. Guide the product through the material to be cut while holding the product at an angle of about 14 ° to
the material.
Always use a sharp blade and turn or change the cutting rails in good time.
Apply cutting oil or other cooling lubricant to the workpiece to prolong the useful life of the cutting
tools.
*2327536*
4
2327536
5 Nm
5 Nm
English 25