Hilti Nuron SSH 6-22 Operating Instructions Manual page 29

SSH­CS,
0.5 ­ 1.5 mm,
, for
straight cuts
Permissible ma- 2.0 mm
terial thickness,
aluminum up to
250 N⁄mm²
Permissible •/•
material
thickness, steel
spiral ducting up
to 400 N⁄mm²
Permissible •/•
material
thickness, steel
spiral ducting up
to 600 N⁄mm²
Starting hole di- 17 mm
ameter
Smallest radius 80 mm
for curved cut-
outs
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 20
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
*2327536*
SSH­CS, SSH­CX,
1.5 ­ 2.5 mm, 0.5 ­ 1.5 mm,
, for
straight cuts straight cuts
in stainless
steel
3.0 mm •/•
•/• •/•
•/• •/•
22 mm 20 mm
150 mm 120 mm
2327536
SSH­CC,
0.5 ­ 1.5 mm,
, for , for curves
2.0 mm
•/•
•/•
15 mm
L 45 mm,
R 80 mm
SSH­CD,
4 x 0.9 mm,
, for spiral
ducting
•/•
4 x 0.9 mm
4 x 0.6 mm
18 mm
150 mm
English 23