Hilti Nuron SSH 6-22 Operating Instructions Manual page 28

4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Typical A-weighted sound power level (L
Uncertainty for the sound power level (K
Typical A-weighted emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Triaxial vibration value (a
Uncertainty (K)
4.3 Blade
Blades of different types are needed, depending on the thickness or strength of the material to be cut. Select
the correct blade for the purpose from the table below.
The blades have two cutting edges. The cutting edges cannot be resharpened.
Initial equipment, as supplied ex works: SSH­CS 1.5 ­ 2.5 mm or SSH­CD4 mm × 0.9 mm
SSH­CS,
0.5 ­ 1.5 mm,
, for
straight cuts
Permissible steel 1.5 mm
thickness, steel
up to 400 N⁄mm²
Permissible steel 1.0 mm
thickness, steel
up to 600 N⁄mm²
22 English
)
WA
)
WA
)
pA
)
h
SSH­CS,
1.5 ­ 2.5 mm,
, for
straight cuts
2.5 mm
•/•
21.6 V
See the end of these operating
instructions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
85 dB(A)
3 dB(A)
) 74 dB(A)
pA
3 dB(A)
B 22­55 8.8 m/s²
B 22­255 9.2 m/s²
B 22­55 1.5 m/s²
B 22­255 1.5 m/s²
SSH­CX, SSH­CC,
0.5 ­ 1.5 mm, 0.5 ­ 1.5 mm,
, for , for curves
straight cuts
in stainless
steel
•/• 1.5 mm
1.5 mm 0.8 mm
2327536
*2327536*
SSH­CD,
4 x 0.9 mm,
, for spiral
ducting
•/•
•/•