Siemens SIMATIC IPC277G PRO Operating Instructions Manual page 30

Installing and connecting the device
3.3 Mounting the device
• One of the following support arms or pedestal systems:
– Support arm or pedestal with mechanical VESA interface and the corresponding
– Support arm or pedestal with mechanical interface for the Siemens base adapter
See section "System components (Page 14)"
• The following cables are fed through the pedestal or the support arm to which the device
is mounted:
– Protective conductor
– Power supply cable
– Data cables, for example, USB
Procedure for mounting
This section describes the mounting of the device to a support arm system. Installation on a
pedestal is carried out in the same way.
For devices of the type "suitable for support arm", the base adapter is screwed to the device
from the top; for devices of the type "suitable for pedestal", it is screwed from below.
A device for a support arm system cannot be used on a pedestal, and vice versa.
NOTICE
Observe the torques
If you apply too much torque to tighten the screws of the backplane cover and the terminal
compartment cover or the screws for fastening the device to a support arm or pedestal, the
threads of the enclosure, intermediate plate or support arm may be damaged.
If you tighten the screws with a torque that is too low, the device is not sealed.
30
Siemens adapter set
(The type of mechanical interface differs depending on the type of support arm or
pedestal.)
For even large connectors to fit, run their cables through the pedestal or support arm
first.
Operating Instructions, 02/2022, A5E51373692-AA
SIMATIC IPC277G PRO