Oven - Daily Use - Electrolux EKG9000Z9X User Manual

12 www.electrolux.com
7.4 Pan supports
The pan supports are not
resistant to washing in a
dishwasher. They must be
washed by hand.
1. Remove the pan supports to easily
clean the hob.
Be very careful when
you replace the pan
supports to prevent the
hob top from damage.
2. The enamel coating occasionally can
have rough edges, so be careful
when you wash the pan supports by

8. OVEN - DAILY USE

WARNING!
Refer to Safety chapters.
8.1 Ignition of the oven gas
burner
CAUTION!
When turning on the oven
burner the oven door must
be opened.
CAUTION!
Make sure that the lid is
opened. When using the
oven the lid has to be
opened to avoid over-
heating.
Oven safety device:
The gas oven has a
thermocouple. It stops the
gas flow if the flame goes
out.
1. Open the oven door.
2. Ignite the oven gas burner.
• For ignition on the spark
generator button push and hold
the button
turn the knob for the oven
functions counterclockwise to the
maximum gas flow position
and push it to light the burner.
. At the same time
hand and dry them. If necessary,
remove stubborn stains with a paste
cleaner.
3. After you clean the pan supports,
make sure that they are in correct
positions.
4. For the burner to operate correctly,
make sure that the arms of the pan
supports are aligned with the centre
of the burner.
7.5 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the
conditions of the gas supply pipe and the
pressure adjuster, if fitted.
Release the spark generator
button when burner lights.
Keep the knob for the oven functions
pushed for 15 seconds or less to let
the thermocouple warm up. If not, the
gas flow is interrupted.
8.2 Manual ignition of oven gas
burner
In case of absence of the electricity you
can ignite the oven burner without an
electrical device.
1. Open the oven door.
2. Hold the flame near the hole in the
bottom of the oven cavity.
3. At the same time push the knob for
the oven functions and turn it
counterclockwise to the maximum
gas flow position.
4. When the flame comes on, keep the
knob for the oven functions pushed
on the maximum gas flow position for
15 seconds or less to let the
thermocouple warm up.