Table of Contents
Advertisement
Sending an Emergency Alarm with Emergency
Call
This feature gives your radio priority access on a channel for
conventional system, and to a talkgroup for trunking system.
Procedure:
1
Press the preprogrammed Emergency button.
2
The display shows Emergency and the current zone or
channel. You hear a short, medium-pitched tone and the
LED blinks red momentarily.
OR
The display shows No emergency, if the selected channel
does not support emergency.
3
The radio enters the Emergency Call state when:
You receive the dispatcher's acknowledgment. The display
shows Ack received.
OR
You receive no acknowledgment. The display shows
No acknowledge.
OR
You press the PTT button while in the Emergency Alarm
mode.
4
Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from
your mouth.
5
Press and hold the PTT button. Speak clearly into the
microphone.
6
Release the PTT button to end the transmission and wait for
a response from the dispatcher.
7
Press and hold the preprogrammed Emergency button for
about a second to exit the Emergency Call mode.
Sending a Silent Emergency Alarm
This feature allows you to send an Emergency Alarm to the
system without triggering any audio or visual indicators.
Procedure:
1
Press the preprogrammed Emergency button.
2
The display shows no changes, the LED does not light up,
and you hear no tones.
3
The silent emergency state continues until you:
Press and hold the preprogrammed Emergency button for
about a second to exit the Silent Emergency Alarm mode.
OR
Press and release the PTT button to exit the Silent
Emergency Alarm mode and enter regular dispatch or
Emergency Call mode.
67
English
Advertisement
Table of Contents
