Gaggenau VL 414 110 Installation Instructions Manual page 13

Insert and align the appliance in the cutout
horizontally. Tighten the rear clamp using the screw
inside the appliance. Tighten the front clamp from
below .
Notes
‒ Do not overtighten the clamps, ensure that there
is a uniform seal gap on all sides.
‒ The rear clamp pivots out on its own during
tightening.
‒ The appliance must not be bonded to the
countertop with silicone.
3 Use the installation aid
downdraft ventilation unit in the recess and align it.
Remove the sealing element. Insert the installation
aid at an angle into the ventilation recess and align
it vertically to the appliance. Position the appliance
at an angle in front of the downdraft ventilation unit
and press it into the recess via the installation aid.
Remove the installation aid. Fasten the downdraft
ventilation unit as described above.
Notes
‒ You must use the included installation aid if the
downdraft ventilation unit is in a combination
with several Vario appliances in the last or last
but one position.
‒ The installation aid protects the appliance edges
from damage.
4 Fit the connection piece in the required position
Notes
‒ Depending on the installation situation, the
exhaust air can be guided in three different
directions.
‒ Corresponding to the space conditions, the
connection piece can be turned by 180°.
Horizontally insert the
.
.
13